Filling The Water Tank; Switching On For The First Time - melitta Caffeo Bistro Manual De Instrucciones

Warning!
Hazard for persons allergic to caffeine.
Since a residual quantity of the previously used beans remains above the
grinder, the two types of beans mix when changing to a different bean type.
Consequently, when switching over to decaffeinated beans the first two cups
may still contain coffee that is not decaffeinated. This means that only the third
cup of coffee prepared after the switchover is free of caffeine.
Note
When the tilt lever is vertical during the brewing process, no beans fall into the
grinder.
4.4

Filling the water tank

Lift the lid of the water tank (Fig. A, no. 3) and pull the water tank up
•
and out of the appliance.
• Fill the water tank to the max. mark with fresh tap water and reinsert it.
4.5

Switching on for the first time

All of the tubes have been drained and aired out at the factory. For this reason,
the symbol for the valve
for the first time and the appliance must be vented using the valve. Venting is only
necessary when starting up for the first time as well as after draining and airing
out. You can find more information on page 75.
Switch the power switch (Fig. B, No. 20) to position „I".
•
• Press the ON/OFF button
→ The ON / OFF button
After the heat-up phase, the valve symbol
• Place a vessel under the Perfect Cappuccino and push the steam pipe
downwards until it is positioned below the brim of the vessel.
• Place a vessel below the outlet.
• Turn the valve switch (Fig. A, no. 6) clockwise to open the valve.
→ The valve symbol
Cappuccino.
52
Heft_Caffeo_Bistro_EU_2.2.indd 52
illuminates after the heat-up phase when starting up
to switch the appliance on.
flashes. The appliance heats up.
flashes. Water runs into the vessel below the Perfect
illuminates.
09.04.2014 14:33:51