Operating Positions; Working With Kneading Hooks, Beaters And Whisks - Kompernaß KH 701 Instrucciones De Uso

Operating positions

Important: Only operate the appliance when
accessories are attached and in the operating
positions shown in this table. NEVER operate the
appliance without ingredients.
Position
1
2
3
Positioning of the mixing bowl
4
Utilisation of kneading hooks,
beaters and whisks
Insertion of large amounts to be
5
processed
Working with kneading hooks,
beaters and whisks
Note: The appliance may only be used when
the drive openings not being utilised are
covered with drive protection lids.
Accessories
To prepare the appliance for work with kneading
hooks q , beaters e and whisk w , proceed as
follows:
• Press the unlocking button f and bring the swivel
arm h into operating position 4 (see chapter
„Operating positions") (Fig. 1).
• Insert the mixing bowl y . The base of the mixing
bowl y must engage in the recesses k on the
appliance.
• Press the unlocking button f and bring the swivel
arm h into operating position 1 (see chapter
„Operating positions") (Fig. 1).
• Place and hold turn switch g in position P, until
the drive motor j remains stationary in the park
position (Fig. 2). Should the drive motor not
move it is already at the park position.
• Press the unlocking button f and bring the swivel
arm h into operating position 4 (see chapter
„Operating positions") (Fig. 1).
• Depending on the task to be performed, insert
the kneading hooks q , beaters e or whisks w so
that they firmly engage in the drive j motor.
Note: The kneading hooks q are fitted with a
pastry deflector. Turn the pastry deflector until the
kneading hooks q can engage (Fig. 3).
• Place the ingredients to be processed into the
mixing bowl y .
Note: Pay heed that during the kneading
and/or mixing process the pastry in the mixing
bowl increases in volume, or is pressed upwards
through the rotary movement. Take note of the
table in the chapter „Recommended filling
quantities".
• Press the unlocking button f and bring the swivel
arm h into operating position 1 (see chapter
„Operating positions") (Fig. 1).
• Place the lid onto the mixing bowl y .
• Set the rotary switch g to the desired level.
- 24 -