Operation Output Automatic; Changeover Mechanism; Safety Valve; Protective Device - Max PowerLite AKHL1050E Manual De Operaciones

Safety Valve

PowerSwitch
4. Connect a MAX Powerlite Nailer MAX powerline Hose to the special air fitting on the part
of the reducing valve H.
Connect a general nail driver air hose to the air chuck on the part of the reducing valve L.
※ Connection to the female fitting is made by simply pressing an male fitting into it.
Prior to connecting the air hose to the machine, be sure to check that air hose and hose
fitting have been completely secured.
4. OPERATION OUTPUT AUTOMATIC CHANGEOVER
MECHANISM
In order to maximize discharge performance, the machine is provided with a
microcomputer-based operation output automatic changeover mechanism. Operation output
is automatically adjusted while the tank internal pressure of the machine reaches the
maximum pressure of 29bar. When this is done, an operation sound changes in order to
switch operation output, but it is not a trouble.
※ The output changeover pressure varies depending on the capacity of the main power
source, use of an extension cord or use of other electric device. If the voltage is too high
or too low, the charging tie becomes longer.
※ If the charging time is too long or the pressure does not increase, recheck a connection to
the power source(connect to the main power source) or avoid combined use with an
electric tool.
5. SAFETY VALVE
The Safety Valve is designed to prevent system failures by relieving pressure from the system
when the compressed air reaches a predetermined level. The Safety valve is preset by the
manufacturer and must not be modified and adjusted in any way. If the Safety Valve works,
take the system to MAX CO., LTD authorized distributors or other specialists and repair it.

6. PROTECTIVE DEVICE

If there is a considerable voltage drop or an abnormality inside the machine at the time of
operation, a motor burnout preventive thermal protector may be activated to stop the motor. If
this is the case;
1. Turn off the Power switch and disconnect the power plug from the plug socket.
2. Check whether a circuit breaker of 230 V AC, 12.5 A or higher current capacity is used,
whether the extension cord is reasonably long, neither too long nor too fine, or whether or
not the identical power source is also used for other electric tool, etc. If so, stop using the
extension cord or electric tool.
15