Max PowerLite AKHL1050E Manual De Operaciones página 16

When using the extension cord or drum cord, be sure to use those of "2.5 mm
thicker and up to 20 m long," in the fully stretched condition.
※ In order to prevent a voltage drop due to use of the extension cord, connect the machine
directly to the main power source, avoiding use of the extension cord as much as
possible.
※ When the main power source is of less than 230 V or when other electric tool is used
simultaneously, the voltage will drop more.
※ The power breaker may be activated, if other electric tool is used on the identical power
source and the total current consumption value exceeds the current capacity of the power
breaker. If this is the case, avoid combined use with the electric tool on the identical
power source.
3. Connect the power plug to the electric outlet socket and turn on the Power switch to restart
operation.
※
Unless the motor is fully cooled down, the protective device may be reactivated
immediately, even if the machine is run again. Also, the machine may not run if the
Power switch is turned on. If this is the case, cool it down naturally for about 30 minutes.
PowerSwitch
4. If the protective device is activated despite that nothing is wrong with the power source or
wiring, the machine is possibly out of order. Contact our nearest distributor or MAX
SERVICE for inspection/repairing.
● Never use a transformer such as a booster for the power source of the machine.
Neglect of this causes a trouble or burnout.(Use of the booster prevents the
machine from being activated.)
● Never use the machine with an engine generator or on the DC power.
Neglect of this causes a trouble or burnout.
16
2
or