To Apply Oil To The Cylinder; Technical Data - Husqvarna W50P Manual De Usuario

7. Move the fuel valve lever (A) to the ON position.
8. Let the fuel drain from the fuel tank.

To apply oil to the cylinder

1. Remove the spark plug.
2. Put approximately 5 cl of clean engine oil into the
cylinder.

Technical data

Inlet/outlet dimension, mm
Total level difference, m
Level difference for the suction hose,
m
Engine model
Maximum discharge capacity, m/h
Fuel tank capacity, l
Net weight/Gross weight, kg
Oil tank capacity, l
Type
Measured Sound Power Level, L
dB (A)
Guaranteed Sound Power Level, L
dB (A)
16
A
Technical data
Husqvarna W50P
50
28
7
168FB
32
3.6
25/27
0.6
Gasoline
108 dB (A)
WA
108 dB (A)
WA
3. Pull the starter rope handle approximately 5 times to
apply the oil equally in the cylinder.
4. Install the spark plug.
5. Pull the starter rope handle slowly. Pull until you feel
resistance and the notch on the pulley aligns with the
hole at the top of the starter cover (A).
6. Slowly move the starter rope handle back to its initial
position.
Husqvarna W80P
80
28
7
168FB
54
3.6
28/30
0.6
Gasoline
108 dB(A)
108 dB (A)
A
1421 - 004 - 09.07.2020