To Start The Product - Husqvarna W50P Manual De Usuario

1. Remove the pump chamber cap (A) from the pump
chamber.
A
2. Fill water to the lower surface of the discharge outlet
(B).
3. Install and tighten the pump chamber cap.

To start the product

CAUTION:
dry. Fill the product with water before
operation to prevent damage to the pump
seal. Refer to
on page 8 .
1. Set the fuel valve lever (A) to the ON position.
2. Set the choke lever to the correct position.
a) If the engine is cold, close the choke (B).
B
1421 - 004 - 09.07.2020
B
Do not operate the product
To fill the product with water
A
b) If the engine is warm, open the choke (B).
3. Apply approximately 1/3 throttle (C).
4. Put the ON/OFF switch (D) to the ON position.
D
B
C
9