Disassembly - Unold 78220 Instrucciones De Uso

then remove the juice collection tray and empty the pomace container. Then
reassemble the appliance and continue processing.
9. If the glas is full, switch the appliance off by placing the switch on "0", pour
the juice into another container and then continue processing.
10. When you have finished preparing juice, switch the switch to "0" and unplug
the plug from the electrical outlet. We recommend that you then immedi-
ately clean the appliance.
11. Note: The appliance has an overheating protection circuit. If the appliance
should become too warm in operation, the overheating protection circuit
switches the appliance off to prevent the motor from being damaged. In
this case, unplug the power plug and allow the appliance to cool for at least
30 minutes.

DISASSEMBLY

When you have finished extracting juice, switch the appliance off, by
placing the switch on "0". Wait until juice no longer flows out and the
stainless steel sieve is no longer turning.
Unplug the plug from the electrical outlet.
1. Remove the juice pitcher.
2. Remove the tamper from the filling shaft.
3. Open the closure bracket by carefully pressing it upward and slightly forward
away from the appliance.
4. Remove the transparent lid.
5. Remove the stainless steel sieve. To do this you must pull gently on the
sieve. However, grasp the sieve only on the edge, since the blades in the
sieve are an injury hazard.
6. Remove the juice collection tray and the pomace container.
7. Empty the pomace container. You can use the flat end of a dish brush for
this.
8. Remove any pulp remaining in the juice collection tray.
28
Copyright UNOLD AG | www.unold.de