Ibiza sound AMP- 300 Manual De Instrucciones página 3

FRONT PANEL – FACADE – FRONTSEITE - VOORZIJDE
REAR SIDE – ARRIERE – RÜCKSEITE - ACHTERZIJDE
3
Front panel controls :
1. On/Off switch with Power LED
2. Gain Control
Input gain control allowing to attenuate the input signal that is sent to the various channels of the amplifier.
The dB control range is as follows:
Fully closed (the signal is at zero and not sent to the channels of the amplifier) or fully open (i.e. at rated
power: the signal is not attenuated at all and sent at the input power into the amplifier channels).
3. LED Display
Shows the master output level.
Rear connections
1. Line input
Jack sockets : These sockets are connected in parallel to the corresponding RCA connectors. Thus, you can
connect a second amplifier in series to the first unit to send the same signal into several amplifiers in order to
increase the audio power.
2. Speaker outputs
Binding posts or XLR/Jack (minimum load 4 Ohms)
Note : To avoid damage to the speakers, only use speakers that have the same impedance and power rating as
the amplifier. Only use speaker cables and never signal cables as those used for microphones, music instruments
and audio equipment in general.
3. Power supply
Mains
©Copyright LOTRONIC2011
3 2 1
2
GB
1
Page 3