Etac Turner PRO Manual De Usuario página 6

Etac Turner PRO / www.etac.com
Checklist after assembly
Don`t start using Turner PRO before completing
the checklist after assembly.
Use this checklist to verify that the Turner PRO is properly installed and
can operate correctly and safely before use. See assembly information on
the previous page for details.
Make sure that the leg support is mounted correctly.
…
Make sure that all three bolts between outer pole and
…
main plate are mounted correctly and properly tightened.
Make sure that the handle (inner pole) is mounted
…
correctly.
Make sure Turner rotates freely.
…
Adjusting handle height
1 2
Turn knob counter Push the lock pin in
clockwise and if the handle is in
adjust handle upper position.
height.
Be aware of handle when adjusting height.
Handle can slide down and hit operators
head or upper body.
Don`t use handle in a position above the lock
pin position. This makes the pole wobbly and
the Turner unsafe to use.
Adjusting leg support height
Turn knob anti
clockwise and
adjust knee
3
support height.
Positioning Turner PRO
1
When correct handle
height is obtained,
turn knob clockwise
to lock the position.
Position the new seat (chair,
wheelchair, toilet or bed) in
an 90 degree angle with the
existing seat.
3
Adjust the height of the leg
support so it is positioned two
fingers beneth the users knee
cap.
6
55
50
1 2
45
40
35
30
When correct
knee support
height is obtained,
turn knob
clockwise to lock
the position.
Make sure knobs are securely tightened. Lose
knobs can cause handle or knee support to
slide down and make the Turner unsafe to use.
2
Slide the Turner PRO in under
the users feet.
4
Adjust the height of the handle
to a position that is comfortable
for both user and assistant.
3
55
50
45
40
35
30
The knee support height
can be read from the scale
on the pole. The number
above the leg support
bracket referes to the
correct height.
50
45
40
35
30