Wheels, Tires; Removing The Front Wheel; Reinstalling The Front Wheel - SHERCO SE 250i Manual De Propietario

SE 250i / 300i

Wheels, tires

reMOving THe FrOnT WHeel

1
3
1
2 3
106
2
Place the motorcycle on a suitable stand.
Remove the two screws
Loosen the two screws
Pull the axle through the right side.
Remove the wheel from the fork.
aTTenTiOn
Do not operate the front brake lever when the front
wheel is removed.
reinsTalling THe FrOnT
WHeel
Check that the brake disc is not dirty or
contaminated with oil or grease. If it is, clean the
disc with brake cleaner.
Brake cleaner
Install the spacer
1
hub.
Install the front wheel in the fork and install the
axle (grease the axle prior to installation).
Tighten the screws
2
Fork screws
Install and tighten the axle nut
Front axle nut
Tighten the screws on the right side of the bike.
Fork screws
Operate the front brake lever several times until
the pads touch the disc.Remove the bike from the
stand and push down on the fork several times.
and the nut
1 2
3
Minerva brake cleaner
and degreaser
on the left side of the wheel
.
M8 12Nm
.
3
M20 25Nm
M8 12Nm