Toshiba TCB-IFGSM1E Manual Del Propietário página 7

TCS-NET GSM Phone Control Interface
(b) Create an SMS message for setting the
destination GSM phone number for
notification. Create the following INFOTEL
message that includes the mobile phone
number to control the air conditioner following
(a).
SETPERMIT
SETPERMIT
INFOTEL
Enter the GSM phone number in INFOTEL
< > as a string of numbers. Space character
can be included.
Up to five GSM phone numbers can be entered
by inserting a new line at the end of the
message above.
INFOTEL
INFOTEL
INFOTEL
INFOTEL
When a PIN is provided, be sure to enter it in
<***> before <GSM phone number>. PIN is a
4-digit to 8-digit code. Space character can be
included. Be sure to enter PIN for all GSM
phone numbers.
INFOTEL
INFOTEL
INFOTEL
(c) Enter the name of the specified air conditioner
in < > following (b). Use alphanumeric
characters for the name. This setting is
necessary to identify air conditioners when two
or more GSM remote monitoring systems.
Make this setting even when one system is
used.
NAME
***
***
***
– 7 –
When a PIN is provided, be sure to enter it in
<***> before <name>. PIN is a 4-digit to 8-digit
code. Space character can be included.
NAME
***
(d) After you have created these SMS message,
send them to the GSM modem telephone
number used in this system.
After a while, the following SMS message is
sent to the GSM phone number that was set in
the SMS message for setting the destination
GSM phone number.
• Response SMS message to indicate
successful initial settings
Name of specified air conditioner:
INITIAL SET OK
• Response SMS message to indicate
unsuccessful initial settings
Name of specified air conditioner:
INITIAL SET NG
When an SMS message that includes "INITIAL
SET OK" is received, the initial settings are
completed.
REQUIREMENT
If an SMS message that includes "INITIAL SET
NG" is received, an invalid message that includes
unspecified characters was sent. Check the sent
messages, and try to send messages until "OK"
response SMS message is received. When a PIN
is provided, check whether the correct PIN code
was entered.
If no response SMS message is received, the
transmit SMS message may not have arrived at
the GSM modem telephone number or the
destination GSM phone number setting may be
incorrect or there may be a problem with the local
site including the GSM modem. Refer to Chapter
6 Troubleshooting.
Nevertheless, if an SMS message including
"INITIAL SET OK" is not received yet, contact the
installer.
Owner's Manual
EN
6-EN