Automatic Power-Off - KPS -TH10 Manual De Funcionamiento

KPS-TH10 • Digital thermohygrometer
screen displays . To continue reading the mesured value,press
again.
3.3 Max-min
Pressing MIN/MAX Max-min is set up, and max updates MIN/MAX constantly,
press MIN/MAX again, it is min. The two stations can be switched. If turn off,
you need to press MIN/MAX for two seconds; a sound shows that this function
has been turned off. Max means that the peak of temperature and humidity,
while min is the lowest reading.
3.4 Saving and transferring the measurements
This meter is able to save 99 groups reading for transferring. Press MEM to
save the reading, and its location displays at the screen's upper right corner.
After two seconds, the meter comes back to the normal state; If RAM is filled
fully, the meter will cover the stored data from No.1 RAM and keep the read-
ing. When transferring the saved figure, press READ to enter MEM check-up.
At this time, DP/WB and are used to change the page. To exit it, press READ
again. In the state of check-up, press MEM for five seconds and "00"is dis-
played at the screen 's right upper corner, which means RAM is cleared.

3.5 Automatic power-off

To prolong the life-span of the battery, this meter offers an automatic power-off
function, and it closes without operation in 30 minutes. This function is ap-
proved. Just press pif closing it for longer measurement, and disap-
pears. Do it again, the automatic power-off is on.
3.6 The backlight
Press to start the backlight, press again to close the backlight. If
starting without automatic power-off, it will close after 15 seconds.
4. MAINTENANCE
• Replace the batteries
The meter is charged with four 1.5(AAA type) batteries. When appears,
the batteries should be replaced as soon as possible. Follow the instructions:
1) Unscrew the top of the entrance.
2) Get the batteries out.
9