Gaggia CAREZZA SIN 042 GM Instrucciones De Uso página 22

7 Cof ee Brewing
Warning! During cof ee brewing it is forbidden
to remove the pressurized i lter holder by manu-
ally turning it from right to left. Danger of burns!
• During this operation, the "
is to be considered as a standard and not a faulty operating
mode.
• Before using the machine, make sure that there is enough
water in the machine tank.
Note: if the steam knob is opened by mistake
during the warm-up phase, the " " light (20)
starts blinking. Close the knob and wait until the ma-
chine is ready.
If cof ee is NOT brewed after pressing the brew
button " " (13), press the brew button "
(13) again and check the "Troubleshooting" table before
removing the i lter holder.
Ensure the machine is ready before brewing cof ee. The ma-
chine is ready when the " " light (14) is steady on.
7.1 Filter Holder Warm-Up
If the "rinse" function is not activated and/or the i lter holder is
to be warmed-up manually, do as follows:
• Insert the pressurized i lter holder into the brew unit
13
(4) from the bottom.
• Turn the pressurized i lter holder from left to right un-
14
til it locks into place. Release the pressurized i lter holder
grip. The handle will turn slightly to the left. This move-
ment guarantees optimum i lter holder performance.
• Preheat the pressurized i lter holder by pressing the
17
(13) button; some water will l ow out of the pressurized
i lter holder (this operation is necessary only for the i rst
cof ee).
• After 50 cc of water have been dispensed, press the (13)
button again to stop the dispensing procedure.
• Remove the pressurized i lter holder by turning it from
19
right to left and then drain the remaining water.
Place a container under the dispensing spout.
Now you can go on with the cof ee brewing procedures de-
scribed in the following sections.
• 22 •
7.2 Using Ground Cof ee
•
•
" light (14) is blinking; this
for original espresso brewing.
•
•
"
•
•
•
•
ered as absolutely normal and is due to the i lter holder
characteristics.
after use.
7.3 Using Cof ee Pods
•
•
•
•
Insert the i lter (23) in the pressurized i lter holder
7
(21); at i rst use, the i lter is already on. With the special
i lter (23) provided there is no need to change the i lter to
make one or two cof ee(s).
Add 1-1.5 measuring scoop(s) for a single cof ee and 2
8
measuring scoops for a double cof ee. Remove any cof ee
residues from the rim of the pressurized i lter holder.
Note: do not press the cof ee, since the i lter
holder is provided with an optimized system
Insert the i lter holder (21) into the brew unit (4) from
13
the bottom.
Turn the i lter holder from left to right until it locks
14
into place.
Take 1 or 2 preheated cups and place them un-
16
der the pressurized i lter holder. Make sure that they are
placed correctly under the cof ee brewing nozzles.
Press the " " button (13).
17
When the desired quantity of cof ee has been brewed,
18
press the " " button (13) again to stop the brewing pro-
cedure. Wait for a few seconds after brewing, then remove
the cups of cof ee.
After brewing, wait until the "
19
stops blinking, then remove the pressurized i lter holder
by turning it from right to left and empty the remaining
cof ee grounds.
Note: a small quantity of water remains in the
pressurized i lter holder. This has to be consid-
Important note: the i lter (23) should be kept
clean to guarantee perfect results. Clean daily
Remove the ground cof ee i lter (23) from the pressur-
9
ized i lter holder (21).
Insert the pod adapter (24) into the pressurized i lter
10
holder (21) ensuring that its convex part faces down.
Then insert the pod i lter (25) into the pressurized i l-
11
ter holder (21).
Insert the pod into the i lter holder; make sure that the
12
paper of the pod does not stick out of the i lter holder.
" cof ee light (14)