Arregui SUPRA Manual De Instrucciones página 6

Ocultar thumbs Ver también para SUPRA:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
<EN>
If an incorrect code is entered, the screen will display ERROR1, for a
second incorrect attempt it will display ERROR2, and for a third incorrect
attempt it will display ERROR3 and the system will remain blocked for 5
minutes, indicating by blinking HOLD 5... HOLD 4... etc. During this time,
the keypad cannot be used.
4. CLOSING THE SAFE
With the safe open, press the
while the locks move, and CLOSED when the door has closed.
NOTE: If the locks encounter an obstacle, they will move back and leave
the door open.
5. OPENING WITH THE EMERGENCY KEY
If you do not have the opening codes, or if the batteries have run out
and an external battery is not available, you can open the safe using the
emergency key.
For this, access the emergency lock. Introduce the key provided with
these instructions and turn it. The safe will open.
Note: In case of an emergency opening due to a wrong code, the
emergency key opens the door but does not unblock the electronic
system.
6. OPENING WITH AN EXTERNAL BATTERY
If the batteries have run out, you can use the safe by placing a 9V battery
in the power supply located to the right of the keypad.
Once the safe is open, replace the batteries.
7. OTHER CONTROL ELEMENTS
SCREEN CONTROL: To configure the screen so it does not display the
digits that are entered, press the
screen will display DP). If you would like the screen to display what you
enter, press the
SOUND CONTROL: To use the safe in silent mode, press the
and then the 6 button (the screen will display SILENT). If you would like
the safe to emit sounds again, press the
will display BUZZER).
BATTERY STATUS CONTROL: If you would like to know whether the
batteries are sufficiently charged, press the
closed. If the batteries are fine, the screen will display HI-BAT, and if they
are not, the message will be LO-BAT. In that case, you should replace the
batteries with new ones.
In any case, if the batteries are not sufficiently charged, the system will
warn you of this when the safe is opened and closed by displaying the
OPEN LO-BAT or CLOSE LO-BAT messages on the screen, respectively.
NOTE: During the battery change process, the safe will not forget the
codes that have been entered.
3 button again (the screen will display DP CODE).
button. The screen will display CLOSE
button and then the 3 button (the
6 button again (the screen
button while the safe is
button

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

240220

Tabla de contenido