dirna Bergstrom bycool SPLIT Instrucciones De Montaje página 12

SPLIT
EN
Recommendations
for assembly
• Before starting assembly, read the instructions and
follow them during the installation process.
• Use appropriate tools for each operation.
Electricity
• Disconnect the contact key.
• Disconnect the battery before starting assembly.
• Check the electrical component connections, ensuring
they are correctly fitted.
Piping
• Ensure the refrigerant duct sleeves are secure and do
not come into contact with sharp or very hot elements.
• Take particular care when making the boreholes and
cutting, making sure there is no damage to the electric
cables or the fuel conduits.
• Take particular care when making the boreholes and
cutting, making sure there is no damage to the electric
cables or the fuel conduits.
• Always tighten the couplings using 2 wrenches to
prevent any breakage.
Torque (N∙m)
Steel quality
Thread
8.8
M6/100 10
M8/125 22
M10/150 45
Torque (N∙m)
Coupling
3/8
1/2
5/8
Torque
10.9
13 10
30 13
61 17
Nut Torque
5/8 15-17
3/4 15-17
7/8 24/27
Ø35 Circular saw
Bore
Ø4, Ø6, Ø9, Ø11 Broaches
10, 13, 17, 19, 22, 24, 27 Wrench
Scissors
Flexometer
Documentation included
Assembly Instructions
Warranty
Fragile
Beware of cuts!
Electrical hazard
!
Installation personnel must have been duly trained
with regards to air conditioning in vehicles.
!
dirna Bergstrom, s. l. shall be released from
any liability should failures occur as a result
of inappropriate handling or installation of the
equipment, or due to modifications or replacements
made without express authorisation from us in
writing.
!
See the warranty procedure for the product included
in Troubleshooting.
!
See the unit's User Manual for the correct operation
of the remote control and the control panel.
!
The following should be provided to the user when
installation is complete: User Manual, Warranty and
Troubleshooting.
!
The unit does not comply with ADR regulations.
12
Air conditioning for vehicles
Tools
220.AA3.5320
220.AA1.0017
Symbology
! Warnings