Infant Car Seat - BABYTREND HC38A Manual De Instrucciones

INFANT CAR SEAT

INFANT CAR SEAT
WARNING:
Avoid serious
injury from falling or sliding out,
always use the Infant Car Seat
harness.
•
ONLY approved SNAP TECH products can be
TM
used on the frame.
ADJUST CAR SEAT HEIGHT
WARNING:
Do not adjust
car seat height with child in seat.
Adjust seat height before placing
your child in the car seat.
WARNING:
Always
check that the Height Adjustment
Bracket is level and both left and
right sides locked before placing
child in the car seat.
WARNING:
Never use
the car seat mode at any of the
higher positions. Always use the
car seat at the lowest position.
WARNING:
Never rest the
height adjustment bracket on the
locking pins.
24) • Squeeze both left and right Release
Handles of the Height Adjustment Bracket
and adjust to the lowest position (Fig. 24a).
DO NOT adjust with child in the seat.
ATTENTION:
The Height Adjustment Bracket must be set at the
lowest postion before placing car seat (Fig. 24b).
17
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Release Handle
Fig. 24a
Lowest Position
Fig. 24b
INFANT CAR SEAT
TO ATTACH CAR SEAT
25) • Connect the Car Seat and lock into place
(Fig. 25a). Make sure its locked firmly in
place before use (Fig. 25b).
TO REMOVE CAR SEAT
26) • Detach Car Seat from Upper Frame
Assembly by pushing both center
buttons on each side of the seat and
lifting seat upwards (Fig. 26).
DO NOT remove with child in the seat.
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Fig. 25a
Fig. 25b
Fig. 26
18