Panasonic EY3610 Manual De Instrucciones página 7

III. ASSEMBLY
Attaching or Removing
Battery Pack
CAUTION:
Before inserting battery pack, check that
the trigger in the tool actuates properly
and returns to the "OFF" position when
released.
1. Remove the battery pack away from the
tool. (Fig. 4)
2. Charge the battery pack using the
battery charger.
3. After charging has been completed,
remove the battery pack from the
charger and connect it to the tool.
Disconnect the charger from the power
source when not in use.
Inserting the sealing
compound into the gun
CAUTION:
Be sure to lock the trigger by setting the
application speed control (J) to "0" position,
and then remove the battery pack away
from the tool beforehand.
For use with cartridge
1) Cut off the tip of nozzle at a point
suitable for the job. (Fig. 5)
2) Unscrew the tube holder from the
housing, and remove the sausage pack
adapter from the rack. (Fig. 6)
3) Screw cartridge adapter on to piston
joint. (Fig. 7)
4) Push the rack all the way in by hand.
(Fig. 8)
5) Install the tube holder on the housing,
remove the front cap from the tube
holder, and insert the cartridge. (Fig. 9)
6) Install the front cap on the tube holder.
(Fig. 10)
For use with sausage pack
1) Cut off the tip of nozzle at a point
suitable for the job. (Fig. 5)
2) Unscrew the tube holder from the
housing.
EY3610_EU.indb 7 EY3610_EU.indb 7
3) Screw sausage pack adapter on to
piston joint. (Fig. 11)
NOTE:
• Make sure that the plunger rotates
smoothly.
4) Push the rack all the way in by hand.
(Fig. 8)
5) Install the tube holder on the housing,
remove the front cap from the tube
holder, and insert the sausage pack.
(Fig. 12)
6) Set the nozzle and install the front cap
on the tube holder. (Fig. 13)
IV. OPERATION
How to use the sealing
gun
1) Attach the battery pack to the tool.
2) Set rack speed according to work. You
can easily change speeds while working
by rotating application speed control (J)
by fi nger.
3) Hold the grip while holding the tube
holder, then squeeze the trigger (I) to
switch on. (Fig. 14)
• The white area of the remaining
amount indicator (G) shows the amount
of sealing compound that has been
left in the cartridge or sausage pack.
When the indicator changes to red
completely, the cartridge or sausage
pack is empty.
4) The tube holder can be rotated. This
makes sealing application even easier in
hard-to-work places.
CAUTION:
• Be sure to lock the trigger ("0" position)
when fi nished working.
Speed rate adjustment
0 1 2
Lock
Slow
• Be sure to remove the battery pack away
from tool when fi nished working.
• Dripping can occur with small nozzle
openings or exceptionally soft sealing
compounds.
7
3 4 5
Fast
2012/07/20 14:22:55 2012/07/20 14:22:55