Attaching The Additional Handle - Metabo LF 724 S Instrucciones De Manejo

en ENGLISH
.../min ..... revolutions per minute
rpm ......... revolutions per minute
~ ............. alternating current
............ alternating current /direct current
n ............. rated speed
4. Overview
See page 2.
1 Protective flap
2 Locking button
3 Additional handle
4 Sliding switch ( 0 / I )
5 Handle
6 Extraction nozzle
7 Extraction connection piece (Ø 35 mm)
8 Graver
9 Multi-socket spanner
a Hexagon
b Torx
10 Planing base
11 Reversible blade
5. Commissioning
Before plugging in, check that the rated mains
voltage and mains frequency, as stated on the
rating label, match with your power supply.
Always install an RCD/GFCI with a max. trip
current of 30 mA upstream.
5.1

Attaching the additional handle

Always work with the additional handle (3)
attached! Attach the auxiliary handle as
shown.
6. Use
Always work with an extraction
system to guarantee perfect
machine operation.
Always guide the machine with both hands on
the handles (3), (5) provided.
6.1 Switching On and Off the paint remover
Switching on
Lift paint remover so that the cutter head is free.
Push the slide switch (4) forward.
I On
In continuous operation, the machine
continues running if it is forced out of your
hands. Therefore, always hold the machine with
both hands using the handles provided, stand
securely and concentrate.
Switching off
Lift paint remover so that the cutter head is free.
Press the rear of the slide switch (4). The slide
switch jumps back.
6
0 Off
Wait until the cutter head is at a standstill
before setting down the machine. An exposed
cutter head can get caught on the surface and lead
to a loss of control and possible serious injury.
6.2 Locking the cutter head
Danger of injury from the sharp edges of the
reversible blades. Lock the cutter head only
when the cutter head is idle! Switch off paint
remover and pull the mains plug from the socket!
Lay the paint remover on its side.
Press the locking button (2) up to the stop and keep
pressed.
Simultaneously turn the cutter head using the
hexagonal wrench (9-a) (any direction). Turn until
the pressed locking button noticeably engages and
the cutter head is locked.
6.3 Setting the axial cutting depth
Danger of injury from the sharp edges of the
reversible blades. Set the axial cutting depth
only when the cutter head is idle! Switch off paint
remover and pull the mains plug from the socket!
Lock the cutter head and keep the locking button
pressed.
Set the desired cutting depth by turning the setting
screw using a hexagonal wrench (9-a).
Possible cutting depths: 0-0.3 mm
Start with a small cutting depth and increase it
gradually until you have reached the optimum
setting for the workpiece to be processed.
Do not leave the hexagonal wrench in
place!