Charging The Device - Daga CPR-700 Instrucciones De Uso

CHARGING THE DEVICE

Before using your hair clipper for the first time, charge for 10-12
hours, and charge 8 hours regularly.
Ensure the product is switched off.
First insert the plug on the end of the mains adaptor lead into the
unit( fig. 1) and then connect the mains adapter to the mains supply
(100~240V, fig. 2) the hair clipper is immediately ready for mains
operation. If the batteries discharge fully, recharge 2 or 3 minutes
later, then switch on for mains operation.
The charging indicator will light up in red, and the light will turns
green after fully charged. Or connect the adaptor to the charging
base, then put the unit into the charging base for charging.
fig. 1 fig. 2
Your hair clipper cannot be overcharged. However, if the product is
not going to be used for an extended period time (2-3 months), un-
plug it from the mains and store. Fully recharge your hair clipper
when you like to use it again.
To preserve the life of your batteries, let them run out every six
months then recharge for 10-12 hours again.
14