Ferm FDAG-750 Manual De Instrucciones página 5

The speed of the machine must not exceed the
value on the grinding disc.
• Make sure that the dimensions of the grinding
disc correspond to the specifications of the
machine.
• Make sure that the grinding disc has been
mounted and fastened properly. Do not use
reducing rings or adapters to make the grinding
disc fit properly.
• Treat and store grinding discs in conformance
with the supplier's instructions.
• Do not use the machine for grinding
workpieces with a maximum thickness
exceeding the maximum grinding depth of the
grinding disc.
• Do not use grinding discs for deburring.
• When grinding discs have to be mounted on
the thread of the spindle, make sure that the
spindle has sufficient thread. Make sure that
the spindle is sufficiently protected and does
not touch the grinding surface.
• Before use, inspect the grinding disc for any
damage. Do not use grinding discs which are
cracked, ripped or otherwise damaged.
• Before use, let the machine run idle for 30
seconds. Immediately switch off the machine in
case of abnormal vibrations or occurrence of
another defect. Carefully inspect the machine
and grinding disc before switching the machine
on again.
• Make sure that sparks do not put people into
danger or that they contact highly flammable
substances.
• Make sure that the workpiece is sufficiently
supported or clamped. Keep your hands away
from the surface to be cut.
• Always wear safety goggles and hearing
protection. If desired or required also use
another kind of protection like for example an
apron or helmet.
• Ensure that mounted wheels and points are
fitted in accordance with the manufacturer's
instructions.
• Ensure that blotters are used when they are
provided with the bonded abrasive product and
when they are required.
• If a guard is supplied with the tool never use
the tool without such a guard.
• For tools intended to be fitted with threaded
hole wheel, ensure that the thread in the wheel
is long enough to accept the spindle length.
Ferm
• Ensure that ventilation openings are kept clear
when working in dusty conditions. If it should
become nessesary to clear dust, first
disconnect the tool from the mains supply (use
non metallic objects) and avoid damaging
internal parts.
• Though poor conditions of the electrical mains,
shortly voltage drops can appear when starting
the equipment. This can influence other
equipment (eq. blinking of a lamp). If the
mains-impedance Zmax <0.348 Ohm, such
disturbances are not expected. (In case of
need, you may contact your local supply
authority for further information.
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Always check that the power supply
corresponds to the voltage on the rating
plate.
Your machine is double insulated;
therefore no earthwire is required.
Replacing cables or plugs
Immediately throw away old cables or plugs when
they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in the
wall outlet.
Using extension cables
Only use an approved extension cable suitable for
the power input of the machine. The minimum
conductor size is 1,5 mm
reel always unwind the reel completely.
3. ASSEMBLY
Prior to mounting an accessory always
unplug the tool.
Mounting the side-handle
Fig. 1
The side handle can be used for both left-hand
and right-hand control.
. When using a cable
2
GB
5