Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY
(1) Pliers
(2) 7/16" Wrenches
(2) 1/2" Wrenches
CAUTION: PARTS OF TRACTOR
MAY BE HOT! MAKE SURE ENGINE
AND MUFFLER ARE COOL BEFORE
INSTALLING SPREADER!
1.
Turn the spreader upside down as shown in figure 1.
2.
Assemble two angle brackets and two 1/4" nylock nuts
onto the ends of the longer bolts already assembled to
the frame tube. Do not tighten yet. See figure 1.
FIGURE 1
3.
Fasten deflector to angle brackets using two 1/4" x
3/4" hex bolts, 1/4" flat washers and 1/4" nylock nuts.
Allow angle brackets to swivel so deflector curves
naturally between angle brackets and then tighten all
nuts. See figure 2.
DEFLECTOR
FIGURE 2
1/4" NYLOCK NUT
ANGLE
BRACKET
1/4" x 3/4"
HEX BOLT
1/4" FLAT
WASHER
1/4"
NYLOCK NUT
4.
Insert agitator hairpin into middle hole in the spreader
shaft. Assemble a seal (turned as shown in figure
3) onto end of the spreader shaft closest to hairpin
agitator. See figure 3.
5.
Slide end of spreader shaft having the seal through the
plastic bushing in the bottom of hopper. See figure 3.
6.
Slide the impeller onto the spreader shaft and secure
it with a 1/8" x 1-1/4" cotter pin. See figure 3.
AGITATOR
HAIRPIN
IMPELLER
1/8" x 1-1/4"
COTTER PIN
FIGURE 3
7.
Assemble a seal (turned as shown in figure 4) onto
the motor shaft. Slide it up against the motor.
8.
Assemble the impeller coupler onto the motor shaft
and secure it with a 1/8" x 1-1/4" cotter pin. Spread
the ends of the pin around the coupler. See figure 4.
1/8" x 1-1/4"
COTTER PIN
FIGURE 4
4
SPREADER
SHAFT
SEAL
SEAL
IMPELLER
COUPLER
Publicidad
Tabla de contenido
