Nussbaum TOP LIFT 2.35 TS Instrucciones De Servicio página 79

Time frame Maintenance
type position
12
1
11
2
10
1 x / 12
9 3
4
8
5
7
6
12
1
11
2
10
1 x / 12
9 3
4
8
5
7
6
OPI_TOP LIFT 2.35 TS TSK TSA - HYMAX INGROUND 2.35 R B P_V1.1_DE-EN-FR-ES-IT
According to manufacturer instructions, the hydraulic oil should be
changed every two years in normal operations.
Various environmental influences e.g. location, temperature swings,
intensive operation etc, can have an influence on the quality of the
hydraulic oil. For this reason, the oil must be checked during annual
safety inspections and maintenance.
The oil is used if it has a milky colour or if the hydraulic oil smells unpleas-
antly.
To change oil, lower the lift is to its lowest position then suction the oil out
of the oil container and replace the contents.
The manufacturer recommends high-quality clean hydraulic oil. The
required oil volume and type is to be taken from the technical data.
After filling (18), the hydraulic oil must be between the upper and low-
er marking on the oil dipstick, or approx. 2 cm below the oil filling open-
ing. Dispose of the old oil according to regulations to the intended lo-
cation (district offices, environmental protection office or commercial
regulatory office has the obligation to disclose about disposal points).
• Remove any sand and contaminants from the lifting post pipes and
load lifting equipment using compressed air.
Shorten the maintenance interval depending on the degree of con-
tamination.
• Clean the wipers of the lifting post pipes with compressed air and
check for damage.
• Check the condition and function of the pusher plates/ramps of the
flat carrier fixtures.
• Check the rollers on the ramps. Exchange if damaged.
• Check the torque of the fastening screws of the load fixture for the
lifting posts.
• Check the condition and function of the foot deflectors (footswitch),
CE stop + warning signal.
Maintenance plan
79