RuarkAudio MRX Guia Del Usuario página 17

This device is labelled in accordance with
European Directive 2012/19/EU concerning waste
electrical and electronic equipment. This symbol
indicates that the product or associated batteries
should not be disposed of as general household
waste. As with any electrical equipment, please
dispose of it according to local regulations.
CE COMPLIANCE INFORMATION
This product conforms to all EU Directive requirements
as applicable by law. You may obtain a free copy of the
Declaration of Conformity by contacting your dealer,
distributor, or Ruark Audio.
Hereby, Ruark Audio, declares that this device complies with
the essential requirements and other relevant provisions of
the European Radio Equipment Directive 2014/53/EU.
You can download the full CE Declaration of Conformity at
www.ruarkaudio.com/doc/mrxdoc.pdf
Troubleshooting
Sometimes resetting your MRx to factory settings can
fix common problems. To reset your MRx complete the
following steps:
1. Disconnect your MRx from the mains power supply.
STEREO MODE SWITCH
2. Set the
3. While holding down the CONTROL KNOB, reconnect the
mains power supply.
Once your MRx has rebooted, it will automatically go into
setup mode (see Setup section). Set it up as normal and
STEREO MODE SWITCH
remember to put the
your desired setting. Resetting it will also clear the Bluetooth
pairing list so you will need to pair your Bluetooth devices
again.
For further help with your product, please refer to the FAQ
(Frequently Asked Questions) page in the support area of our
website.
For more information visit www.ruarkaudio.com/support
EN
DA
DE
to the LEFT position.
FR
IT
ES
back to
NL
NO
EN-17