AGV AX-8 Manual De Instrucciones página 17

1
2
1
2
3
CLICK !
To re-install the peak, first retighten the central plastic screw.
Position the peak so that the opening on the cursor is in line
with the hole on the shell (1). Introduce the screw in the cursor
into the hole on the shell (2) and tighten it manually.
Then tighten the side screws. Start on one of the two sides of
the helmet and position the aluminium washer in line with the
respective holes on the shell and the peak. Then insert the
aluminium screw and tighten it (3).
3
4.2) Muzzle air inlet Removal/Installation
To remove the muzzle air inlet, press from the inside of the
helmet on the upper part of the inlet as shown in figure 1.
To refit the muzzle air inlet, position the filter and metal grid (2)
in the hole in line with the inlet, ensuring that both edges are in
line with those of the hole in the shell.
Now insert the muzzle air inlet into its lower housing and then
in to its upper housing (3) until it clicks into place, indicating
the correct position and insertion of the air inlet.
N.B. Before checking that
the peak works properly, en-
sure that the plastic screw
under the peak is loosed so
that the cursor is free.
Lower the peak and check
that it works properly.
17 2