Mounting The Deflector - Stihl MF-MM Manual De Instrucciones

English
Tighten the first screw moderately.
–
Tighten the second screw
–
moderately.
Tighten down first screw firmly.
–
Tighten down second screw firmly.
–
NOTICE
It must not be possible to rotate the
gearbox on the drive tube.
Mounting the Dethatcher
NOTICE
Left-hand and right-hand dethatchers
are different.
The direction of rotation is marked with
arrows on the gearbox and flange. Make
sure both arrows point in the same
direction.
The spring tines may be damaged or
break if the direction of rotation is wrong.
12
5
Rotate the left-hand dethatcher (4)
N
on the shaft until it can be pushed
into position – check the direction of
rotation again (arrows).
Insert hitch pin (5) in hole in shaft
N
and snap it into position.
Mount the right-hand dethatcher in
N
the same way.
WARNING
Always mount both dethatchers.

Mounting the Deflector

Mounting and Removing the Deflector
Extensions
4
Mounting
1
Slide both deflector extensions onto
N
the right and left sides of the
deflector, push them fully home at
the top and bottom and engage the
tab (1).
Removing
Use the combination wrench to
N
disengage the tabs (1) and then pull
off the extensions.
WARNING
The deflector extensions divert removed
material and debris away from the
machine and the operator. Never work
without a properly mounted deflector
extensions.
1
MF-MM