Technical Specifications; Operating Instructions - entrematic Ditec QIK4E-7EH-7YEH Manual De Instalación

3. Technical specifications
Power supply
Absorption
Line fuse
Torque
Insulation class
Opening time
Closing time
Bar length (max)
Service class
Intermittence
Temperature
Degree of protection
Control panel
3.1

Operating instructions

Service class: 4 (minimum 10÷5 years of working life with 100÷200 cycles per day).
Applications: INTENSE (for apartment block, industrial and commercial entrances and car parks
with vehicle access or access for intense pedestrian use).
Service class: 5 (minimum 5 years of working life with 600 cycles per day).
Applications: VERY INTENSE (for apartment block, industrial and commercial entrances and
car parks with vehicle access or access for very intense pedestrian use).
- Performance characteristics are to be understood as referring to the recommended weight (ap-
prox. 2/3 of maximum permissible weight). When used with the maximum permissible weight
a reduction in the above mentioned performance can be expected.
- Service class, running times, and the number of consecutive cycles are to be taken as merely
indicative, having been statistically determined under average operating conditions, and are
therefore not necessarily applicable to specific conditions of use.
- Each automatic entrance has variable elements such as: friction, balancing and environmental
factors, all of which may substantially alter the performance characteristics of the automatic
entrance or curtail its working life or parts thereof (including the automatic devices themselves).
The installer should adopt suitable safety conditions for each particular installation.
i
Every automatic system contains variable elements (friction, balancing and environ-
mental factors) that may substantially alter both the lifespan and performance of the
system or its components (including the spring). Tests have shown that the average
spring lifespan is around 300.000 cycles, so you are advised to check its state of wear
when this limit is reached. If there are clear signs of wear, or it is difficult to balance
the bar correctly, replace the spring.
QIK4E
230 V~ 50 Hz
1,5 A
F1,6A
90 Nm
Class 1
4 s/90°
4 s/90°
3700 mm
4 - INTENSE
S2 = 15 min
S3 = 30%
min -20° C max +55° C
IP24D
E1A
QIK7EH-QIK7YEH
230 V~ 50/60 Hz
1 A
F1,6A
70 Nm
Class 1
2÷6 s/90°
2÷6 s/90°
6000 mm
5 - VERY INTENSE
S2 = 60 min
S3 = 60%
min -20° C max +55° C
IP24D
EL31R
28