9. TROUBLE SHOOTING
Check the following before contacting technical support:
Problem
Cause
The unit does
The power is not con-
not work.
nected.
The water tank is full.
The water tank has not
been replaced correctly.
The device
does not de-
The air filter is clogged.
humidify.
The temperature or rela-
tive humidity in the room
where the device operat-
ing is too low.
The room is too large.
The dehu-
midifier
There are too many
works, but
sources of humidity.
reduces the
relative hu-
midity insuffi-
There is too much venti-
ciently.
lation.
BEFORE CALLING FOR SERVICE
The following are not defects.
A hissing noise or hol-
low sound:
A squeaking noise:
Odor:
The unit does not start
nor change operation
mode immediately:
Solution
Insert the plug into the
wall outlet.
Remove the water from
the container.
Place the water tank in
the correct position.
Clean the air filter.
It is normal that the de-
vice does not dehumidi-
fy in these conditions.
We recommend using a
dehumidifier with a
greater capacity.
We recommend using a
dehumidifier with a
greater capacity.
Reduce ventilation (e.g.
close windows and shut
doors.)
This sound is generated from the
refrigerant flowing within pipes.
This noise is generated from the
unit when it is expands or contracts
with temperature changes.
Such odor as tobacco, cosmetics,
or foods may accumulate in the
unit.
To prevent overloading the com-
pressor motor, the unit will be
stopped for more than 3 minutes.
10. SPECIFICATIONS
MODEL
DEHUMIDIFYING CAPACITY
POWER SOURCE
POWER CONSUMPTION
OPERATING CURRENT
OPERATING TEMP. RANGE
DIMENSIONS (W×H×D)
WEIGHT
COMPRESSOR
REFRIGERANT
NOTE: Dehumidifying capacity will vary according to temperature
and humidity of the room.
CONTAINS FLUORINATED GREENHOUSE GASES COVERED BY
THE KYOTO PROTOCOL.
HERMETICALLY SEALED SYSTEM
GWP information (according to (EC) No 517 / 2014
3
ENGLISH
TD-C210
10 L/day (30°C, 80%RH)
Single Phase 220-240V/50Hz
210 W
0.95 A
5°C ~ 35°C
290 × 478 × 190 mm
8.6kg
ROTARY
R-134a / 92g