ARP ODYSSEY Manual De Usuario página 11

k . Filter modulation level slider (yellow)
Adjusts how the filter is opened and closed by S/H (sample and hold) or the LFO.
l . Filter modulation level slider (pink)
Adjusts how the two envelope generators (AR and ADSR) control the filter.
m . VCA level slider (red)
Adjusts the level at which the envelope generators (AR and ADSR) control the
VCA. In practical terms, this is the master volume of the ODYSSEY.
If the DRIVE switch is on, this also adjusts the VCA distortion.
n . Filter input source (NOISE/RING MOD) switch . . . . . . . . . . . . . . . . . . [NOISE, RING MOD]
Selects either noise or ring modulator.
o . Filter input source (VCO-1 wave) switch . . . . . . . . . . . .[VCO-1
Selects the VCO‐1 waveform (sawtooth or square).
If you select square wave, you can raise the PULSE WIDTH slider (page 7) to
change from a square wave to a pulse wave.
p . Filter input source (VCO-2 wave) switch . . . . . . . . . . . [VCO-2
Selects the VCO‐2 waveform (sawtooth or square).
If you select square wave, you can raise the PULSE WIDTH slider (page 8) to
change from a square wave to a pulse wave.
q . Filter modulation source (KYBD CV/S/H MIXER OR PEDAL) switch . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .[KYBD CV, S/H MIXER OR PEDAL]
Selects the source that will control the filter.
If you select KYBD CV (keyboard control voltage), the signal normally used to
convey key information from the keyboard to the VCO can be used to open and
close the filter. For example, you can produce an effect in which the filter opens
more for higher notes.
If you select S/H MIXER OR PEDAL, the signal sent from the S/H MIXER
will open and close the filter. If an optional (separately sold) volume pedal is
connected to the PEDAL jack, you can use the signal of the pedal to control the
VCF, producing an effect like a wah pedal.
r . Filter modulation source (S/H/LFO) switch . . . . . . . . . . . . . . . . . . . . . . . . . . .[S/H, LFO
Selects the source that will control the filter.
You can produce a wah effect by using the LFO to modulate the filter.
s . Filter modulation source (ADSR/AR) switch . . . . . . . . . . . . . . . [ADSR
Selects the envelope generator that will control the filter.
t . VCA EG switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [AR
Selects the envelope generator that will control the VCA.
, VCO-1 ]
, VCO-2 ]
]
- 11 -
, AR ]
, ADSR ]