Acquisition Procedure For Double-Shutter Without Slowing; Operation Sequence - Aprimatic G-MATIC AP350 Instrucciones Para La Instalacíon Mecánica, El Uso Y El Mantenimiento

6.9

ACQUISITION PROCEDURE FOR DOUBLE-SHUTTER WITHOUT SLOWING

Regulate the TORQUE trimmer to the minimum degree necessary to make the gate move properly and regulate the
SLACK slowing force trimmer to the maximum value (complete rotation clockwise).
6.9.1

Operation sequence

•
Close the gate completely.
•
Press the PROG.A learning button for at least 3 seconds
•
The DL6 learning LED starts to flash
•
Release the PROG.A button
•
Press START: the first shutter begins to open at standard speed
•
When the shutter has opened completely, press START: the second shutter begins to open at standard speed
•
When the shutter has opened completely, press START: the second shutter begins to close at standard speed
•
When the shutter has closed completely, press START: the first shutter begins to close at standard speed
•
When the shutter has closed completely, press START
•
Press START: the first shutter begins to open and as soon as you decide that the displacement time of the
shutter is sufficient press START again: the second shutter begins to open
•
Press START: the second shutter begins to close and as soon as you decide that the displacement time of the
shutter is sufficient press START again: the first shutter begins to close
•
Wait until the DL6 LED turns off.
•
Acquisition finished
•
The subsequent manoeuvre will be standard within the parameters just set
12 sec).
DS41035-001
After resetting or after supplying the board, the first closing manoeuvre time is longer (about
30
LBT0197