Mitsubishi Electric Mr.SLIM PLA-RP BA Serie Manual De Instrucciones página 7

5. Operation
< How to set the fixed up/down air direction (Only for
wired remote controller) >
Note:
●
This function cannot be set depending on the outdoor unit to be connected.
• For PLA-(Z)RP . BA series, only the particular outlet can be fixed to
certain direction with the procedures below. Once fixed, only the set
outlet is fixed every time air conditioner is turned on. (Other outlets
follow UP/DOWN air direction setting of remote controller.)
■
Explanation of word
• "Refrigerant address No." and "Unit No." are the numbers given to
each air conditioner.
• "Outlet No." is the number given to each outlet of air conditioner.
(Refer to the right.)
• "Up/Down air direction" is the direction (angle) to fix.
Reset 1 2
horizontal
Operation buttons (During the fixed airflow direction mode)
TEMP.
MENU ON/OFF
BACK MONITOR/SET DAY
OPERATION
PAR-21MAA CLOCK
Mode button (Return button)
Moves between the selected(blinking)
parts.
Unit No. Outlet No.
Set temperature buttons
Changes the selection(No.).
Unit No.
Outlet No.
"1-4"
"1-4"or "0"
3 4 5
ON/OFF button
Resets the fixed airflow direction mode.
Fan Speed button
ON/OFF
Filter button
FILTER
(<Enter> button)
CHECK TEST
Sends the information on
CLEAR
remote controller display.
Check button (Clear button)
·Refer to the next page for details.
Up/Down air direction Refrigerant address No.
Down Up
Refrigerant address No.
Up/Down air direction
"00-15"
5 steps or
cancel
Horizontal airflow
Remote controller setting
The airflow direction of
this outlet is controlled by
the airflow direction setting of
remote contoller.
Outlet No.3
Outlet No.2
Note: "0" indicates all outlets.
Pressing the button with either refrigerant
address No., unit No. or outlet No. blinking, ...
Press for 2 Only the air conditioner with the No. on remote
seconds to
controller and its outlet are set to the setting 5.
change / cancel
(Other outlets are closed.)
"Fixed airflow
It is used to identify the air conditioner and
direction mode".
outlet to set.
Pressing the button with
Up/Down air direction indicater blinking
Attention
Only the air conditioner with the No. on Remote controller
and its outlet are fixed at "Up/Down air direction"
blinking.
This is used only to decide direction conclusively.
Attention: Be careful not to set wrong air conditioner.
Downward
Fixing
The airflow direction of
this outlet is fixed
in particular direction.
When it is cold because of direct
airflow, the airflow direction can
be fixed horizontally to avoid
direct airflow.
Outlet No.4
MITSUBISHI
ELECTRIC
label
Outlet No.1
7