KREAFUNK wiCHARGE GO Manual De Instrucciones página 12

Wireless charge operating state
Standby
Operating
Fault
Turn-off
When using wiCHARGE GO to charge another device, you can press the
multifunctional button to enable the wireless charging output function. If
your device is not Qi-charging compatible the wireless charging function
will be disabled automatically within 1 minute. If you remove your device
from wiCHARGE GO the wireless charging function will automatically be
disabled within 2 minutes. Once the wireless charging function has been
disabled you must press the multifunctional button again to enable it.
Upon wireless charging, make sure to align the center of your Qi-compatible
device to the center of wiCHARGE GO; if the wireless charging can't be
initiated, please adjust the position of your device until the correct charging
state is shown on your device.
12
Wireless charge indicator state
Off
Blink
Fast blink
Off
English