Appendix; Selection Of Tip; Servicing And Cleaning Of Airless Hard-Metal Tips; Spray Gun Accessories - WAGNER PROSPRAY 3.20 Manual De Instrucciones

APPENDIX

13
APPENDIX
13.1

SELECTION OF TIP

To achieve faultless and rational working, the selection of the
tip is of the greatest importance.
In many cases the correct tip can only be determined by
means of a spraying test.
SOME RULES FOR THIS:
The spray jet must be even.
If streaks appear in the spray jet the spraying pressure is either
too low or the viscosity of the coating material to high.
REMEDY: Increase pressure or dilute coating material. Each
pump conveys a certain quantity in proportion to the size of
the tip:
The following principle is valid:
There is a large range of tips with various spraying angles.
13.3

SPRAY GUN ACCESSORIES

Flat jet adjusting tip
up to 250 bar (25 MPa
Spray width at about 30 cm
Tip
removal of spray object
Bore mm
marking
Pressure 100 bar (10 MPa)
15 0.13 - 0.46
20 0.18 - 0.48
28 0.28 - 0.66
41 0.43 - 0.88
49 0.53 - 1.37
Tip extension with
slewable knee
joint (without tip)
Length: 100 cm Order no. 0096 015
Length: 200 cm Order no. 0096 016
Length: 300 cm Order no. 0096 017
20
large tip = low pressure
small tip = high pressure
5 - 35 cm Paints
5 - 50 cm Paints, fillers
8 - 55 cm Paints, dispersions
10 - 60 cm Rust protection paints
- dispersions
10 - 40 cm Large-area coats
Tip extension
15 cm, F-thread, Order no. 0556 051
30 cm, F-thread, Order no. 0556 052
45 cm, F-thread, Order no. 0556 053
60 cm, F-thread, Order no. 0556 054
13.2
SERVICING AND CLEANING OF AIRLESS
HARD-METAL TIPS
STANDARD TIPS
If a different tip type has been fitted, then clean it according
to manufacturer's instructions.
The tip has a bore processed with the greatest precision.
Careful handling is necessary to achieve long durability. Do
not forget the fact that the hard-metal insert is brittle! Never
throw the tip or handle with sharp metal objects.
The following points must be observed to keep the tip
clean and ready for use:
1. Turn the relief valve handle fully counterclockwise (
Circulation).
2. Remove the tip from the spray gun.
3. Place tip in an appropriate cleaning agent until all
coating material residue is dissolved.
4. If there is high-pressure air available, blow out tip.
5. Remove any residue by means of a sharp wooden rod
(toothpick).
6. Check the tip with the help of a magnifying glass and, if
necessary, repeat points 3 to 5.
Flat jet
Use adjusting tip
Order No.
0999 057
0999 053
0999 054
0999 055
0999 056
ProSpray 3.20
Contact protection
for the flat jet adjustment tip
Order No. 0097 294
15 cm, G-thread, Order no. 0556 074
30 cm, G-thread, Order no. 0556 075
45 cm, G-thread, Order no. 0556 076
60 cm, G-thread, Order no. 0556 077