Zuzi 4201/50 Manual De Instrucciones página 22

Please follow the processes of use of this manual.
This manual should be available for all users of this equipment.
Always use original components and supplies. Other devices can be similar but they can damage the equipment.
The spectrophotometer is supplied with a Schuko standard wire. It has to be plugged to an earth connection and
the socket should be handy and ready to unplug the equipment in case of emergency.
Never try to repair the spectrophotometer by yourself, since you will lose the warranty and may provoke dama-
ges to the general operating system or the electrical installation, as well as injuries to the people that usually han-
dle the spectrophotometer (burns, hurts...) or damages in nearby equipments.
In the event of breakdown please contact your distributor to overhaul through Zuzi Technical Assistance
Department.
Cleaning
Never use scourers or substances that can grate for cleaning metallic parts such as stainless steel, aluminium, coa-
tings, etc. as they damage the spectrophotometer and produce an early ageing of the equipment.
Use a fluff-free cloth dampened with soaped water that does not contain abrasives.
ATTENTION!! IF EQUIPMENTS ARE NOT PROPERLY CLEAN AND DISINFECTED THEY WOULD
NOT BE ALLOWED TO REPAIR BY OUR TECHNICAL SERVICE.
At the end of its life cycle, please, do not dispose of this equipment by throwing it in the usual garbage;
hand it over a collection point for the recycling of electrical and electronic appliances. It does not contain
dangerous or toxic products for humans but a non adequate disposal would damage the environment.
The materials are recyclable as mentioned in its marking. By recycling material or by other forms of re-
utilization of old appliances, you are making an important contribution to protect our environment.
Please inquire at the community administration for the authorized disposal location.
Page. 22 Instruction manual 54201050 Revision 2 November-2010