AXIL NC1205 Manual De Usuario página 23

C. 12v Car jump starter start up steps:
(Note: Make sure the battery indicator in 3 or above 3)
1. Before you connect cable to the NC1205 external battery, you must first connect
Red POsitiVE (+) battery post, then the Black clamp to the NEGA-
the clamp to the
tiVE (-) battery post.
2. Once the clamps are connected to the battery, plug the cable into the NC1205
external battery and then press the ON button.
3. Start your vehicle. DO NOt allow your ignition to crank for more than three sec-
onds. If your vehicle dosent't start, wait one minute and try againt.
4. Once your vehicle starts, prompty disconnect the cable from your NC1205 external
battery and then unclamp the Black and then Red cable from the battery.
D. LED lights switch on different modes:
1. Long press the switch button with 2 seconds to start the LED lighting function,
then short press the switch button, it will show as follows: lighting, SOS, strobe.
Long press the switch button with 2 seconds to close it.
E. Charge for phones / tablet computers and other elec-
tronic products :
1. Connect the charging cable with NC1205 external battery USB 5V outlet.
2. Connect the charging connector with phones/tablet computers and other electron-
ic products.
3. Press switch button to charge for phones / tablet computers and other electronic
products.
4. When they are fully charged, pull out the charging cable, NC1205 external battery
will shut down in 15s automatically.