Machine Assembly - HOLZMANN MASCHINEN BBS350 Instrucciones De Servicio

The hazardous zone is in the area of 2.5 m from each side of the machine. In the
hazardous area there must not be any unauthorized personnel. In the hazardous zone there
must not be any other items and the ground must be flat to prevent any stumbles.
The whole area of the hazardous zone must be bordered by the fence with the entrance gate.
The fence must have the following parameters:
- mesh with the size of mesh loop 50mm
- total height of the mesh min. 1m
- a distance of 2-3m between columns
- the gate must be fitted with a padlock. The keys from the padlock must only be given to the
service employee and the operator. The fence is not part of the machine and must be
constructed by the machine operator before commissioning the machine!
15.2

Machine assembly

The sawhead is delivered pre-assembled, the following steps are necessary for assembling the
machine.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
1. Assembly the track
Assemble the individual tracks and secure them
loosely with the nuts and bolts provided. It is
important not to tighten the screws completely at
this stage. This happens after the head has been
mounted and rolled along the track.
It is recommended to assemble the track on a solid
and flat surface. Attach the feet at a height of
about 10 cm.
This allows easy removal of the sawdust under the
track and the height adjustment of the block
supports, as well as easier leveling of the track.
Attach the rail cross carriers to the "L " profile with
the supplied screws and nuts. The joining plate is
used to connect the two tracks together. Do not
fully tighten the screws until the head has been
assembly and saw head run is check.
At the end of the tracks, mount and tighten sled
attacks (4 pieces in total).
NOTICE
Make sure the tracks run parallel
and are already well leveled.
Tighten the screws only after
sawhead assembly and controlling
the running properties of the
sawhead.
2. Log support assembly onto the track
Assemble log support pieces as shown below and
use water proof grease on threaded handle and
"T" handle. Attach assembly to the track using the
provided nuts & bolts and tighten.
Attach log support assembly to track as shown
below with the 2 bolts and washers provided. Note
that there are various locations along the track
where this assembly can be bolted.
Insert log supports into track cross supports and
secure with "T" handles. The "T" handle threads
should be coated with waterproof grease.
ASSEMBLY
25
BBS 350