Charging The Battery - Taurus SPIRO Manual De Instrucciones

Barbero perfilador
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
SERVICE:
- The appliance has been oiled
in origin, In order to maintain
the appliance in good oper-
ation conditions we suggest
greasing the blades every time
you clean it by putting a few
drops of oil on the ends of the
blade, and finally switching
on the appliance during a few
seconds.
- Make sure that the appliance
is serviced only by specialist
personnel, and that only origi-
nal spare parts or accessories
are used to replace existing
parts/accessories.
- Any misuse or failure to follow
the instructions for use renders
the guarantee and the manu-
facturer's liability null and avoid.
DESCRIPTION
A Body
B On/off switch
C Blades
D Suction Inled
E Deposit
F Air filter
G Charging indicador Led
H Comb guide
I
Mesurement selector
J Lubricating Oil
K Brush
L Comb
M Charger
If the model of your appliance
does not have the accessories
described above, they can also
be bought separately from the
Technical Assistance Service.

CHARGING THE BATTERY:

- Caution: a new battery is
not fully charged and must
therefore be charged before
the appliance is used for the
first time.
- Charge the battery at an
atmospheric temperature of
between 4 and 40ºC.
- Connect the charger to the
jack using the socket on the
appliance. The socket is locat-
ed at the lower/back part of the
appliance.
- Plug the charger (M) into the
mains.
- The pilot light (G) will come on
to indicated that the charger is
charging the battery.
- Approximately 6 hours are
needed for a complete charger
of the battery. Never attempt
to overcharge the battery (al-
though it is recommended that
the first charge of the battery
be of 8 hours in duration).
- When the battery is charged
disconnect the charger from
the mains supply.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

903909000

Tabla de contenido