Samson Concert 88x Manual De Propietario página 13

Quick Start - Single System Setup
Turn on the power to the transmitter by pressing
and holding Power switch. The indicator LED will
light green.
Press the SCAN button for more than 2 seconds
(the display will start to flash quickly) on the front of
the CR88x receiver to scan for an available channel.
Once the optimal channel is selected the receiver
7. Install batteries
will enter IR Set mode. The display will flash slowly
in IR Set mode.
If you want to set a transmitter to the receiver's
currently selected channel, press and hold the SCAN
button for more than 10 seconds (until the display
flashes slowly) to enter IR Set mode directly.
Position the transmitter about 6"–12" (15cm–30cm) from the front of the CR88x with the
transmitter's IR window facing the IR transmitter on the front panel of the CR88x receiver.
5. Plug receiver into audio system
7. Install batteries
Concert 88x Wireless System
8. Turn on belt pack transmitter
8. Press button on transmitter to turn on
3. Plug in receiver
6. Press Select button to change channel
4. Turn on receiver
8. Turn on belt pack transmitter
9. Pre
13