Faucet And Sprayer Installation; Strainer Installation - Transform QL030 Manual Del Usuario

Installation (continued)

FAUCET AND SPRAYER INSTALLATION

Before installing, carefully unpack the faucet and ensure no parts
are missing .
- Insert the spray housing support through the pre-drilled
hole on the sink corner . Screw the nut onto the threads and
hand tighten .
- Run the spray hose down through the spray housing and up
through the centre faucet mounting hole . Connect the spray
hose to the faucet and tighten with a wrench .
- Install the new faucet on sink with hot "H" to the left and
cold "C" to the right . From under the sink, thread mounting
nuts and rubber gaskets onto the faucet shanks and tighten
the mounting nuts .

STRAINER INSTALLATION

- Apply plumbing putty or silicone sealant to the top side of
the drain opening .
- Insert the strainer body into the drain opening and press it
down until it is evenly seated .
- Assemble the rubber gasket, friction washer and strainer
locknut onto the strainer body from underneath the sink .
Hand tighten the strainer locknut until it is snug .
Do not overtighten .
- Insert the plastic flange into the flange-end of the tailpipe
(not supplied) then secure the tailpipe to the strainer body
using the connecting nut . Tighten the connecting nut until it
is snug . Do not overtighten .
- Remove excess sealant from around the drain opening .
NOTE:
The tail pipe is not supplied.
Faucet shank
Rubber gasket
Faucet shank nut
Sink
7
Please contact cs@conglomkb.com or 1-877-333-0098 for further assistance .
Sprayer and hose
Faucet
Sprayer housing
support
Nut
Strainer Basket
Strainer Body
Sealant
Rubber Gasket
Fiber Washer
Strainer Locknut
Plastic Flange
Tailpipe
Connecting Nut
CONGLOMKB .COM