Gps.device; Mp3.Music - SCHUBERTH SRC‑SYSTEM S2 Manual De Instrucciones

7.2 GPS DEVICE
To.use.a.Bluetooth®.enabled.GPS.device.with.the.SRC-System™,.you.
must.first.pair.the.two.devices..This.will.allow.your.GPS.to.transmit.
navigation.instructions.and.audio.to.the.speakers.of.your.headset.
NOTE: Not all Bluetooth® GPS devices allow connections to Bluetooth® audio devices.
Please consult your GPS User Guide for more information.
PAIRING THE HEADSET TO A GPS DEVICE:
1.. Turn.on.your.GPS.and.turn.on.your.headset..
2.. With.the.SRC-System™.turned.ON,.press.and.hold.the.Volume Up.Button.for.at.
least.six.seconds.until.the.Red.and.Blue.Lights.begin.flashing.simultaneously.
3.. Search.for.Bluetooth®.devices.on.your.GPS.by.following.the.instructions.in.
the.GPS.User.Guide..After.a.few.seconds.the.GPS.will.list."SRCS" (incl. its
software version).as.a.discovered.device..Select.it.and.follow.your.GPS's.
instructions.to.accept.the.pairing.
4.. If.your.GPS.device.prompts.for.a.PIN.or.Passkey.enter.0000.(four.zeros).
5.. Your.GPS.device.will.confirm.that.pairing.has.succeeded..Your.SRC-System™.
will.begin.flashing.slowly.in.Blue..
IMPORTANT
If you wish to use a Bluetooth® mobile phone to make and receive calls through the
headset, you should pair your mobile phone to your GPS device by following the
instructions in your GPS User Guide.
NOTES:
1. If the pairing process is not completed within two minutes the headset will return
to Standby mode
2. The priority schedule of your SRC-System™ has been set in a way to avoid
incoming intercom calls to interrupt GPS instructions in progress. In such case the
intercom caller will hear a busy signal and you will hear two beeps, indicating
that an intercom caller is trying to page you (see section 4.6 for details on audio
priorities of paired devices).
38
MAN00097 QG SRC-S2_C3 J 009.indd 38
7.3 MP3 MUSIC
7.3a WIRELESS A2DP
Your.headset.is.designed.to.receive.wireless.stereo.music.from.A2DP.sources.and.
mobile.phones.that.support.the.Bluetooth®.A2DP.and.AVRCP.profiles.(mostly.3rd.
generation.devices)..
Using.a.Bluetooth®.device.that.supports.the.AVRCP.profile.will.allow.you.to.
operate.all.major.A2DP.source.functions.directly.from.your.headset.
NOTE: The SRC-System™ can also receive audio via the enclosed cable from non-
Bluetooth® MP3 Players or audio sources as described in section 7.3b
While.listening.to.music.from.an.A2DP.source,.you.will.not.miss.any.mobile.or.
intercom.calls,.as.the.headset.will.automatically.stop.the.music.giving.preference.
to.the.incoming.call..However,.after.you.terminate.your.call,.some.MP3.sources.
may.not.automatically.continue.but.require.manual.re-activation..
SETTING UP YOUR MP3 PLAYER FOR BLUETOOTH STEREO A2DP
TRANSMISSION
To.use.a.Bluetooth®.Stereo.(A2DP).enabled.MP3.Player.to.listen.to.stereo.music,.
you.must.first.pair.the.device.to.your.headset..
PAIRING THE HEADSET TO AN MP3 PLAYER
NOTE: If your A2DP source is integrated inside your Mobile Phone, then you should
pair it with your headset as described in section 7.1 above
1.. Turn.on.your.MP3.Player.and.make.sure.that.its.Bluetooth®.function.is.activated.
2.. With.the.SRC-System™.headset.turned.ON,.press.and.hold.the.Mobile.Button.
for.at.least.six.seconds.until.the.Red.and.Blue.Lights.begin.alternating.rapidly:
3.. Search.for.Bluetooth®.headsets.on.your.MP3.Player.by.following.the.device's.
instructions.
4.. After.a.few.seconds.the.MP3.Player.will.list."SRCS" (incl. its software
version).as.a.discovered.device..Select.it.and.follow.your.MP3.Player's.
instructions.to.accept.the.pairing.
7/18/12 5:38 PM