Setting The Temperature Limiter - Miomare HG02523 Instrucciones De Montaje

water can lead to serious damage to buildings
or household fittings and furniture. Check all
connections for leaks carefully.
Ensure that all seals are correctly seated to
prevent leakage of water.
CAUTION! DANGER OF SCALDING!
When making the hot water setting please ensure
that the temperature of the water is not too high.
Before installation, make yourself familiar with
all the existing services, e.g. water connection
and stopcocks.
Please read carefully through these operating
instructions before installing and using the product.
Keep all the safety advice and instructions in a
safe place for future reference!
Installation
Installing the tap
Turn off the main water supply to prevent serious
leakage of water. Allow any remaining water
in the pipework to drain.
Install the tap as shown in figs. A–C.
CAUTION! Do not bend the hoses or place
them under tension. Otherwise material damage
could result.
Attaching the pop-up waste
Install the pop-up waste as shown in fig. D–F.
Using the pop-up waste
See fig. G.
Flushing the tap
The tap must be flushed through before first use
to remove any dirt. To do this, follow these steps
(see fig. H):
Screw the mixer nozzle
18 GB/MT
off.
17
Open the main water supply and allow the
water to run for two minutes.
Then screw the mixer nozzle on again.
Operation
Bringing into use
Note: If the tap has not been used for a long period
flush the pipes through thoroughly in order to avoid
stagnation and build-up of residues in the drinking
water supply.
Open the main water supply.
Lift the control lever
or left to regulate the strength or temperature
of the water flow.
Hot water:
Swivel the control lever to the left.
Cold water:
Swivel the control lever to the right.
Check that the mixer tap is working properly.
To do this, swivel the lever into all the possible
positions. Please check the connections regularly
for leaks.

Setting the temperature limiter

The cartridge in this unit has a temperature limiter.
22
This function is not activated in the factory (neutral
setting).
CAUTION! Change the temperature limiter
setting only after the tap has been installed.
Turn off the main water supply.
Remove the red / blue hot / cold label
fully by a small flat screwdriver (see fig. I).
Release the locking screw
clockwise using a hexagon socket screw key.
CAUTION! Do not take the screw completely
out; just loosen it until the control lever
be easily taken off.
and swivel it to the right
16
care-
19
by turning it anti-
18
can
16