Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5.
Overview
Refer to the illustrations on page 2 of this manual.
Bullet Camera
1
base
2
cover
Dome Camera
1
base
2
IR LED
6.
Operation
6.1
Placing the Batteries
Bullet Camera
1.
Slide the cover towards
the front of the bullet
camera and open the
battery compartment.
2.
Place 2 x AAA batteries
(not included) minding the
polarity.
3.
Slide the cover onto the
housing to close the
battery compartment.
4.
The bullet camera is now
ready to be installed (see
Installation below).
Dome Camera
1.
Open the battery compartment on the underside of the dome camera.
2.
Place 3 x AA batteries (not included) minding the polarity.
3.
Close the battery compartment.
6.2
Installation
1.
Choose your installation spot. You may install the camera in a visible spot and in such way as to
cause a dissuasive effect.
2.
Use the base as a template. Mark the position of the screw holes with a pencil.
3.
Drill the necessary holes using an appropriate electric drill (not included).
4.
Place a nylon plug in each of the holes.
Bullet Camera
5.
Fix the bullet camera using the included screws.
Dome Camera
5.
Fix the base of the dome camera using the included screws. Remember to leave the screws a few
millimetres out in order to hold the camera.
6.
Slide the dome camera onto the screws and twist it in a clockwise direction to fix.
V. 01 – 06/03/2015
CAMD13
3
lens
4
IR LEDs
3
lens
4
©Velleman nv
Publicidad
Tabla de contenido
