Optimus UMX-02/0 Manual De Instrucciones página 73

2. Groups
The contact output will be activated when a
particular group is selected. This selection
occurs, for example, when an audio input
associated with that group is activated.
To confi gure this option, select Groups and
press MENU/OK.
Enter the number
of the group whose
selection activates
the contact output.
Press the MENU/OK key to save the data.
5
Press key to enable this option.
Section II. Confi guration / 7.1. shows a
block diagram typical of this functionality,
such as information on the creation of
subzones.
3. Events
The contact output will be activated in
accordance with the detection of an event
start (Gong Start or Message Start) at a
particular input, and it will be deactivated in
accordance with an end event (Gong End
or Message End ).
To confi gure the
events, select events
and press MENU/
OK.
• Confi guration of Event Start
Select Event Start and press MENU/
OK.
- Disabled. No event is detected.
- Gong Start.
activated when the Gong is started
at a pre-established input.
- Message Start. The contact is
activated when the message is
started at a pre-established input.
• Confi guration of End Event
- Disabled. No event is detected.
- Gong End.
deactivated when the Gong ends
at a pre-established input.
- Message End. The contact is
deactivated when the message
ends at a pre-established input.
UMX-02/0 v1.0
UMX-02/0
C a r d 1 o S C C t 1
G r o u p N u m b e r ?
0 _
C a r d 1 o S C C t 1
D i s a b l e d
G r o u p s
E v e n t s
The contact is
The contact is
• Confi guration of Input
This establishes the input number
whose gong or message acts as a
start and end event.
Once the start events, end event and
input are confi gured, press CANCEL
to return to the contact confi guration
menu.
5
Press key to enable the contact
output confi guration by events.
4. Activated by PC
In this case the control PC activates and/or
deactivates the contact output.
Select Activated by PC and press key
ENGLISH
5
.
Eng
73