SATA spray master RP Instrucciones De Servicio página 122

Operating Instructions SATA spray master RP
EN
■ Never make any unauthorised modifications or technical changes to the
spray gun.
■ Every time before using the spray gun, check the unit with all connected
components for any signs of damage and ensure it is fitted firmly; carry
out any necessary repairs.
Materials
■ Processing acidic or alkaline materials is prohibited.
■ The processing of solvents with halogenated hydrocarbons, petrol, ker-
osene, herbicides, pesticides and radioactive substances is prohibited.
Halogenated solvents can result in explosive and corrosive chemical
compounds.
■ The processing of aggressive substances containing sharp, abrasive
pigments is prohibited. This includes for example various kinds of adhe-
sives, contact and dispersion adhesives, chlorinated rubber, materials
resembling plaster and paints filled with coarse fibres.
■ Never bring more solvent, paint, varnish or other dangerous materials
into the working environment of the spray gun than you need continue
working. Always move these materials to correct storage rooms after
work has finished.
Operating parameters
■ Only operate the spray gun within the parameters stated on the name-
plate.
Connected components
■ Only use original SATA accessories and spare parts.
■ The connected hoses and lines must reliably withstand the thermal,
chemical and mechanical loads expected during operation.
■ When pressurised hoses work loose, their whip-like movements can
cause injuries. Always vent the hoses completely before they are loos-
ened.
Cleaning
■ Never use acidic or alkaline cleaning agents to clean the spray gun.
■ Never use cleaning agents based on halogenated hydrocarbons.
Point of use
■ Never use the spray gun in the vicinity of ignition sources, such as
naked flames, burning cigarettes or non-explosion-proof electrical
equipment.
■ Only use the spray gun in well ventilated rooms.
122