Craftsman 580.754930 Instrucciones De Uso página 12

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTICE
Before starting the pressure washer, be sure
,ou are wearing safety goggles as described below.
WARNmNG
Risk of eye injury.
Spray could splash back or propel objects
resulting in serious injury.
o Always wear indirect vented (chemical splash) safety
goggles marked to comply with ANSI Z87.1 when using or
in vicinity of this equipment.
NEVER substitute safety glasses or dry-condition goggles
for indirect vented safety goggles.
NOTICE
This unit is equipped with a ReadyStart®
engine. A ReadyStart engine means there is no priming
or choking required.
9.
When starting engine, position yourself as
recommended and grasp starter grip handle and
pull slowly until you feel some resistance. Then pull
rapidly to start engine.
WARNmNG
Starter cord kickback
(rapid
retraction)
will pull hand and arm toward
engine faster than you can let go which
could cause broken
bones, fractures,
bruises,
or sprains
resulting
in serious injury.
NEVER pull starter cord without first relieving spray gun
pressure.
When starting engine, pull cord slowly until resistance is
felt and then pull rapidly to avoid kickback.
After each starting attempt, where engine fails to run,
always point spray gun in safe direction, press red button
and squeeze spray gun trigger to release high pressure.
Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury when spray gun kicks back.
10. Return recoil starter slowly. DO NOT let rope "snap
back" against starter.
NOTICE
Pressure washer is equipped with an
automatic idle control The idle control will lower engine
speed when spray gun trigger is released.
11. Point spray gun in a safe direction, push the red
button to release the trigger lock, and pull the trigger.
WARNING
The high pressure stream of water that
this equipment
produces could cut through
skin and its underlying tissues, resulting in
serious injury and possible amputation.
Spray gun traps high water
pressure,
even when
engine
is stopped
and water
is disconnected,
which
could result in serious
injury.
DO NOT allow CHILDREN to operate pressure washer.
Keep high pressure hose connected to pump and spray
gun while system is pressurized.
NEVER aim spray gun at people, animals, or plants.
DO NOT secure spray gun in open position.
DO NOT leave spray gun unattended while machine is
running.
NEVER use a spray gun which does not have a trigger
lock or trigger guard in place and in working order.
Always be certain spray gun, nozzles and accessories
are correctly attached.
WARNING
Exhaust
heat/gases
could ignite
combustibles,
structures
or damage
fuel tank causing
a fire, resulting
in
death or serious
injury.
Contact
with muffler area could cause burns
resulting
in serious injury.
DO NOT touch hot parts and AVOID hot exhaust gases.
Allow equipment to coot before touching.
Keep at least 5 ft. (1.5 m) of clearance on all sides of
pressure washer including overhead.
It is a violation of California Public Resource Code,
Section 4442, to use or operate the engine on any forest-
covered, brush-covered, or grass-covered land unless
the exhaust system is equipped with a spark attester, as
defined in Section 4442, maintained in effective working
order. Other states or federal jurisdictions may have
similar taws.
Contact the original equipment manufacturer, retailer, or
dealer to obtain a spark attester designed for the exhaust
system installed on this engine.
, Replacement parts must be the same and installed in the
same position as the original parts.
How to Stop Your Pressure
Washer
1.
Release
spray gun trigger and let engine
idle for
two minutes.
2.
Push engine rocker switch to OFF (0) position.
3.
ALWAYS
point spray gun in a safe direction,
push red button and squeeze
spray gun trigger to
release
retained
high water pressure.
WARNING
The high pressure stream of water that
this equipment
produces could cut through
skin and its underlying tissues, resulting in
serious injury and possible amputation.
Spray gun traps high water
pressure,
even when
engine
is stopped
and water
is disconnected,
which
could result in serious
injury.
, Keep high pressure hose connected to pump and spray
gun while system is pressurized.
, ALWAYS point spray gun in safe direction, press red
button and squeeze spray gun trigger to release high
pressure, every time you stop engine.
12

Publicidad

Tabla de contenido
loading

Tabla de contenido