Orbegozo CR 6010 Manual De Instrucciones página 16

CR 6000 – CR 6010
If you select low or full output, choose the desire temperature with the thermostat. With the
thermostat, the temperature can be regulated steplessly. When the desired temperature is reached,
the until will automatically switch off. Once the temperature has fallen below the pre-set level, the
heater will switch on again.
A pilot light will allow you to check the thermostatic regulation. When the appliance is heating, this
power on indication light be on. It will be on. It will go out when the desired temperature is reached.
Thermostat knob:
With the thermostat knob you can set a constant room temperature. When the selector switch is set to
position I or position II the heater will automatically switch on as soon as the room temperature falls
below the set temperature.
As soon as the set temperature falls is reached, the switch will turn off.
Rotate the knob clockwise to obtain a higher temperature setting or anti-clockwise for a lower
temperature setting.
You may adjust the thermostat during use.
MAINTENANCE
Before undertaking any maintenance operation, disconnect the appliance from the power supply.
-
This appliance does not require any particular maintenance. For cleaning it is recommended to use
-
a soft moist rag and neutral detergent. Do not use an abrasive cloth or devices which could affect
the outward appearance of the appliance. Check that the parts exposed to the heat rays and the
ventilation are free of dust and dirt.
During cleaning, be careful not to touch the quartz heating elements.
In case of breakdown and/or poor function of the appliance, disconnect the appliance from the
-
power supply and contact an authorized service center. Always request the use of original spare p
arts.
The non-observation of these instructions can compromise the safety of the appliance and render
guaranty invalid.
16