Taurus NIXUS Manual De Instrucciones página 24

- Turn the appliance on, by using the on/off button.
- Select the desired cutting height using the comb height selector
(F). Press it and adjust the height according to the desired cutting
length.
HOW TO CUT THE HAIR:
- Situate the person whose hair you are going to cut so that the top
of their head is at your eye level. Place a protective towel or cloth
around their neck.
- To obtain best results is better to use the appliance on dry hair, as
it is much easier to control the hair and the results.
- Comb hair well before cutting. Make sure that there are no tangles
or knots.
- Hold the appliance in calm and relaxed manner in order to ensure
maximum control of the cut and uniform result. Proceed to use
short cuts gradually going around the head.
- Leave the hair a little longer than desired length as it can always
be altered later.
- While working adapt the comb/comb guide to the desired result.
- At regular intervals, stop cutting in order to comb the hair and
check the results so far.
STEP 1 – NAPE:
- Attach the comb guide size 3 / 6 mm.
- Hold the appliance with the razor facing downwards and begin to
cut the hair from the base of the neck.
- Make some upward movements, raising the appliance gradually
and away from the head, cutting the hair gradually until the height
of the ears (Fig.3).
STEP 2 – BACK OF HEAD:
- Attach comb guide size 9 / 12/ 15 /18 mm and continue with the
back of the head (Fig.4).