Agri-Fab 45-01764 Manual Del Usuario página 3

For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
3. Turn the front angle assembly and bottom panel upside
down as shown in figure 3.
4. Lay the two side angles on the bottom panel so that
the two holes for the axle clamps are closer to the front
angle assembly. See figure 3.
5. Secure both axle clamps to the side angles and the
bottom panel using four M6 x 30 screws, lock washers
and hex nuts. Make only finger tight until axle is
assembled. See figure 3.
M6
HEX
AXLE
NUT
CLAMP
M6X30
SIDE
SCREW
ANGLE
FIGURE 3
6. Secure both side angle assemblies to the bottom panel
using four M6 x 25 screws, flat washers and hex nuts.
Make only finger tight until all four screws are in place,
then tighten securely. See figure 4.
M6
HEX
Ф6
NUT
FLAT
WASHER
M6X25
SCREW
FIGURE 4
ENGLISH
FRONT
Ф6
ANGLE
LOCK
ASS'Y
WASHER
BOTTOM
PANEL
SIDE
ANGLE
3
www.mymowerparts.com
7. Stand the cart on its front end with the front angle as-
sembly on the floor. See figure 5.
8. Temporarily place four large flat washers (used on wheel
axle) on the inside of front angle assembly. See figure
5.
These washers act as shims and are just
for assembly purposes. You will remove
them later to use on axle.
BOTTOM
PANEL
LARGE
FLAT
WASHER
FRONT
ANGLE
ASS'Y
FIGURE 5
9. Lay the front panel down onto the front angle assembly,
on top of the four large washers. See figure 6.
FIGURE 6
NOTE
FRONT
PANEL
FRONT
ANGLE
ASS'Y
LARGE
FLAT
FRONT
WASHER
PANEL