Technical Data; Special Safety Instructions - Probuilder 81534 Manual De Instrucciones

WALL AND CEILING SANDER WITH TELESCOPIC SHAFT
Introduction
To get the most out of your new wall and
ceiling sander with telescopic shaft, please
read this manual and the enclosed safety
instructions before use. Please also save the
instructions in case you need to refer to them
at a later date.

Technical data

Voltage/frequency:
Output:
Speed:
Sanding pad:
Length:
Weight:
Sound pressure, L :
pA
Sound level, L :
wA
Hand/arm vibration:
Measurement values as per EN60745-2-3 and
EN 60745-1
With 4.5 m cable and VDE plug
Includes adapter, 6 pieces of sandpaper in
various grains, 1 set of carbon brushes, an
Allen key, screwdriver and 4 m suction hose
230 V ~ 50 Hz
710 W
700-1,700 rpm
Ø 220 mm
142-192 cm
4,6 kg
88.17 dB(A), KpA 3 dB
99.17 dB(A), KpA 3 dB
2.418 m/s ,
2
K: 1.5 m/s
2

Special safety instructions

This wall and ceiling sander is only designed
for surface sanding of rendered walls and
ceilings and wooden or plaster walls and
ceilings.
Always use a dust mask and, where
appropriate, safety goggles when using the
wall and ceiling sander.
Keep the cord well clear of the working area.
Do not put the sander down until it has
completely stopped.
Be aware that static electricity may form
when using the wall and ceiling sander.
Avoid running the sanding head over nails,
screws or other jutting objects on the
surface, as this may cause damage to the wall
and ceiling sander.
GB
27