Operation Mode; Installation Instructions; Installing The Monitor - PNI DF-926 Manual De Usuario

OPERATION MODE

1. When a guest presses the call button on the outdoor unit, the indoor unit will ring and will
display the image taken by the video camera.
2. Keep pressing the button
minutes.
3. To allow the guest access, press the button
4. If you do not answer the call, the screen will automatically turn off after 30 seconds.
5. Even if the dial button on the outdoor unit has not been pressed, press the key
preview the outdoor camera. In this situation, the screen will close after 10 seconds.
6. Press the button
7. Press the button

INSTALLATION INSTRUCTIONS

Notes:
• For installation, we recommend that you call a qualified personnel with experience in
mounting video intercoms and access control systems.
• Pay close attention to the connections between the monitor, the camera and the electric
lock. See the connection diagram at the end of this manual.
• In case of mounting more than one monitor (2 or 3) strictly follow the wiring diagram at the
end of this manual and install the sense diodes exactly as in that diagram.
• Follow the recommended section of wires according to the installation distance
5 - 30 m
30- 60 m
60 - 100 m
• In case of distances greater than 50 m, measure the output voltage from the indoor
unit, and the one that reaches the outdoor unit. Differences greater than 1V must be
compensated with a power source with adjustable voltage at the output (eg switching
power source PNI ST3.4A 12V 3.4A)

INSTALLING THE MONITOR

1. Install the monitor's mounting bracket on the wall using the screws included in the
package
2. Connect the cables to the monitor
3. Attach the monitor to the bracket
User manual
to speak with the guest. The maximum intercom time is 2
to send an alarm audio signal to the outdoor unit.
to choose the desired ringtone.
(electric lock unlocking)
6 x 0,5 mm
6 x 0.75 - 1 mm
6 x 1 – 1,5 mm
to
4