Cognex In-Sight 2000 Serie Manual De Instrucciones página 6

Precautions
To reduce the risk of injury or equipment damage, observe the following precautions
when you install the Cognex product:
This device requires the use of an LPS or NEC class 2 power supply. Any
l
other voltage creates a risk of fire or shock and can damage the
components. Applicable national and local wiring standards and rules must
be followed.
Route cables and wires away from high-current wiring or high-voltage
l
power sources to reduce the risk of damage or malfunction from the
following causes: over-voltage, line noise, electrostatic discharge (ESD),
power surges, or other irregularities in the power supply.
This product is intended for industrial use in automated manufacturing or
l
similar applications.
The safety of any system incorporating this product is the responsibility of
l
the assembler of the system.
Do not install Cognex products where they are exposed to environmental
l
hazards such as excessive heat, dust, moisture, humidity, impact, vibration,
corrosive substances, flammable substances, or static electricity.
Do not expose the image sensor to laser light. Image sensors can be
l
damaged by direct, or reflected, laser light. If your application requires laser
light that might strike the image sensor, use a lens filter at the corresponding
laser wavelength. For suggestions, contact your local integrator or
application engineer.
This product does not contain user-serviceable parts. Do not make
l
electrical or mechanical modifications to product components.
Unauthorized modifications can void your warranty.
5